How to Replace a Nissan Juke Spare Key

Nissan Juke is a fun and stylish hatchback with an unusual engine setup. It's a bit noisy but it's still a lot of fun to drive.

Replace the battery in the key fob of your Nissan Juke every two years or when it's at a low. You can do it yourself, however you'll need tools.

Dead Coin Battery

If your Nissan Juke key fob isn't functioning the first thing you need to check is the coin battery inside it. It could be dead and must be replaced. This is a simple fix that takes only a few minutes. You can do this by flipping the fob and opening the tiny latch/release located on the back. Remove the old battery and then put in a new one, making sure it's facing downwards in the fob and line up the two halves of the fob with care.

The fob will need to cleaned if it was exposed to water before you can install an entirely new battery. This can be accomplished using a paper towel along with isopropyl alcohol or electronic cleaner, and allow it to dry completely before re-inserting battery.

The key fob has to be linked to the vehicle to be able to start the car. This can be done by following the directions in the owner's manual or an OBDII scanner. If the key fob hasn't been paired, that is the most likely reason of why it has stopped functioning. It is also possible that The KeyLab fob has malfunctioning chips, but this is not common. In this case, a new receiver module might be required. If this is the scenario, the module will need to be replaced by an accredited technician.

Water Damage

Key fobs are powered by batteries and the batteries must be replaced every two years or as soon as your car stops responding when you press the "start" switch. The key's rubber seals keep out water, but submerging the key fob in ocean or pool water can harm the chip's electronic. If this happens you'll have to purchase a replacement key from Nissan or locksmith.

It's possible that the computer has lost connection with the key fob This could be due to a number of reasons. A simple restart of your car will resolve this issue, but if the key is still showing the "Key ID" error message, you'll need to contact Nissan or an auto locksmith for help.

Three common causes are dead key fob battery as well as a key not programmed, or a damaged key fob. The first two are easy to resolve, while the latter is a bit more difficult to identify and repair on the spot, The KeyLab but it is usually fixable with some patience. Compare Nissan Key Replacement prices near you with WhoCanFixMyCar and book your repair online. Read reviews about local Nissan dealerships, Nissan mechanics, and garages in a matter of seconds.

Faulty Chip

The key fob inside your Nissan Juke has a special chip that transmits an electronic signal to the car whenever you turn it. If the chip is not functioning properly, The KeyLab it can cause the key to cease functioning. If this happens it is only possible to solve the issue by replacing the key. Your Nissan Juke key may be damaged due to several reasons, including water damage or the battery of your coin is dead.

If your key fob stops working after an immersion in the wash or bath, you should check the chip for damage from water. Make sure that the metal clips holding it are not loose and the chip isn't exposed to any water. If you see any indications of water damage on the electronic component, you should remove the battery and wipe it down with isopropyl alcohol or electronic cleaner.

If the chip is defective If the chip is defective, you'll need to call your local locksmith or dealer. In order to find a replacement, they will require the year, model and year of your car. You will also have record your VIN (Vehicle ID Number) so that the dealer or locksmith knows what key you have. This will enable them to check the correct key code and ensure that they cut the correct key.

Faulty Receiver Module

The key fob transmits a radio signal to your vehicle to perform various functions. It can open your trunk while you rush with groceries to the car or start your car by pressing the fob's button. It can also open your windows and turn on the horn when you accidentally lock the keys inside your car.

If the key fob isn't able to function, it could be due to a glitch in the receiver module. The receiver modules are tuned to receive specific frequencies that match the signals that are transmitted by the Nissan key fob. If your car has a faulty receiver module, it will stop responding to any signal from the key fob.

It's a good idea to have an extra Nissan key fob in the event that your original key is lost or breaks. A locksmith or dealership can program a spare key to work with your Nissan. This will allow you to avoid the hassles of losing your keys or locking them inside your car.

If your Nissan Juke's key fob was exposed to rain or clean tap water, you can solve the issue by cleaning it using isopropyl or an electronic cleaner. If the chip has become damaged, you'll need to buy a new keyfob which can be programmed for your vehicle by a locksmith or dealer.